How Electrical Wire Manufacturer Use the Pull Plate?

Have you ever wondered how electrical wire manufacturers produce electrical wires ? Although there are different manufacturing processes for electrical wires, the most common one is the pull plate. For example, electrical wires are usually made of pull plates. Pull plates can convert conductive metallic materials, such as copper, into electrical wires. In order to better understand the drawing board and how it works, let's discuss it.

What is the pull plate for the production of wires

A pull plate is a mold that contains one or more holes that electrical wire manufacturers use to make holes for producing electrical wires. They are usually made of high carbon steel. Since the unstretched wire is forced through the hole in the pull plate, it will take the size and shape of the corresponding hole. A process called drawing, which aims to make the cross section smaller. The undrawn electrical wire will have a smaller cross-section through the hole.

Overview of the wire drawing process

The wire drawing process of wire manufacturers is relatively simple. First, attach the pull plate to a work fixture, such as a vise. Then insert the end of a thick wire into an appropriately sized hole. After gripping the same end of the original wire with pliers, the worker pulls it through the pull plate.

It should be noted that drawing is characterized by the use of pulling force. Workers must pass undrawn undrawn wire through the hole in the draw plate. This is in stark contrast to squeezing electrical wires. Stretching requires pulling, squeezing requires pushing.

Advantages of using pull plates to produce electrical wires

The electrical wire drawing board at the wire manufacturer is simple and easy to use. You can use them to make electrical wires with just a few basic tools, including work jigs and pliers.

Most pullers from electrical wire manufacturers support the creation of wires of various sizes. Each hole represents a different American Wire Gauge (AWG). Some pull plates have 20 holes, while others have 30 or more holes. So you can usually make dozens of sizes of electrical wire with a single puller. See the Solar Cable manufactured by JZD Cable.

Disadvantages of using pull plates to produce electrical wires

For small batch applications, a pull plate may work just fine. However, if a electrical wire manufacturer wishes to produce large quantities of electrical wire, a different solution may be required.

Producing large quantities of electrical wire using pull tabs can be time-consuming. You must pull the thick electrical wire through the pull plate. However, for mass production electrical wire processes, there are better commercial electrical wire drawing machines that are more practical.

Well, the above is the introduction of " how wire manufacturers use electrical wire drawing boards to p ", I hope it can help everyone! It is recommended to continue to pay attention to JZD Cable to learn more about wire and cable information.